OUR PRODUCTS
I-type ladder MH
| Structures | Building, Other, Shaft, Tower |
|---|---|
| Fastening surface | Concrete, Masonry, Other, Steel |
| Surface of the substrate | Other, Plane (flat), Round (tube), Steel grid |
| Fall protection | Fixed ladder |
| Fall protection material | Anodized aluminum, Stainless steel, Steel hot dipped galvanized |
Center stile ladder with integrated guide rail incl. Profile connector with locking tabs and screws
- Available in aluminum, steel and stainless steel
- All rungs are ergonomically shaped; for a safe step
- Conforming arrester system type Twinstop®
3 variants for your requirements
MH-ST
Steel St-tZn, hot-dip galvanized (1.0037)
- Rung distance: 280mm
- Step width per side: 150mm
- Rung surface: perforated and anti-slip
- Anti-skid: left and right 24mm high
- Guide rail: 50x32mm
- Catch distance: 140mm
- Overall size (bxt): 386x50mm
- Segment length: 1120-4480mm in increments of 280mm; standard lengths: 2240mm, 2800mm, 4480mm
- Weight: 4,6kg/m
- Minimum bending radius of 1000mm possible for segments
- Mounting distance: Max. 1400mm - recommended 1120mm | max. 315mm from rail end without / max. 14500mm with reinforcement profile
MH-VA
Stainless steel, pickled (1.4401/1.4571)
- Rung distance: 280mm
- Step width per side: 150mm
- Rung surface: perforated and anti-slip
- Anti-skid: left and right 24mm high
- Guide rail: 50x32mm
- Catch distance: 140mm
- Overall size (bxt): 386x50mm
- Segment length: 1120-4480mm in increments of 280mm; standard lengths: 2240mm, 2800mm, 4480mm
- Weight: 4,6kg/m
- Minimum bending radius of 1000mm possible for segments
- Mounting distance: Max. 1400mm - recommended 1120mm | max. 315mm from rail end without / max. 14500mm with reinforcement profile
MH-AL
Aluminum, anodized (3.3206)
- Rung distance: 280mm
- Step width per side: 150mm
-
Sprout surface:
anti-slip - Anti-skid: left and right 24mm high
- Guide rail: 52x51mm
- Catch distance: 140mm
- Overall size (bxt): 392x51mm
- Segment length: 1120-4480mm in increments of 280mm; standard lengths: 2240mm, 2800mm, 4480mm
- Weight: 3,5kg/m
- Minimum bending radius of 3000mm possible for segments
- Mounting distance: Max. 1680mm - recommended 1400mm | max. 380mm from rail end without / max. 1500mm with reinforcement profile
MH bends
It is possible to adjust the riser path to the substructure.
The minimum bending radius is indicated in the boxes above.
All technically feasible bending types can be found in the data sheet.
These components you need for your fall protection system
- Guide rail or ladder with integrated guide rail
- Fastening element
- Profile connector
- Climbing lock bottom 12 kN
- Climbing lock top 12 kN
- Identification plate
- Collecting device
